Lubegard 95030 Engine Flush, 15 oz.

Lubegard Engine Flush boasts superior features compared to traditional oil filters, which can typically remove impurities up to 25 microns, even with a high-quality filter. However, the most hazardous impurities to your engine are between 5 and 20 microns. These impurities are larger than the finest tolerances in your engine, yet too small for oil filters to remove, causing approximately 60 percent of wear.

If these harmful impurities are not flushed out with a quality flush product, sludge, tar, varnish, and wear metals will continue to circulate within the engine and accumulate in the passageways, oil pump, and oil pan. These impurities will lead to excessive wear, higher operating temperatures, and reduced lubrication. After an engine is contaminated, regular oil changes do little to restore its operating efficiency. The newly changed oil becomes dirty again within a short period, and actually helps to accelerate the formation of even more sludge and varnish.

After flushing, it is recommended to always use Lubegard bio-tech engine oil protectant (sold separately) with each oil change. This product is specifically formulated to reduce engine temperatures and minimize friction and wear. Lubegard's bio-tech engine oil protectant also replenishes oil components that have been lost in the stress of operation, saving fuel, providing a smoother, quieter, and cooler engine, and increasing engine life.

To use Lubegard Engine Flush, follow the manufacturer's directions if using a flush machine. Without a flush machine, with the engine warm, check the oil level and add new oil if necessary. Then, add one bottle of Lubegard Engine Flush and circulate at idle for 5 to 10 minutes. Stop the engine and drain as usual, allowing sufficient time for the system to drain completely. Install a new oil filter and refill with new engine oil in the grade and quality level recommended by the manufacturer.

For best protection and additional assurance of top performance and reduction in the formation of further sludge and varnish, always use Lubegard BIO-TECH Engine Oil Protectant with each oil change.

Note that high-mileage vehicles and those that have not been maintained properly, according to their service manuals, should have the oil screen and pan examined and cleaned of accumulated dirt and wear materials. Failure to do so can reduce lubricant flow and may lead to engine damage.

Lubegard Engine Flush can be used before changing oil in gas or diesel engines, and it contains no harmful solvents to damage seals or gaskets. It safely removes accumulated amounts of varnish, sludge, and by-products of combustion, and is a premium synthetic blend that contains special detergents and dispersants to prepare the engine for fresh oil.

product information: